Paper shark

How to create a moving Paper Shark using your Bostik Glue Stick in just a few easy steps!

Instructions

STEP 1: Fold

Cut the blue A4 sheet in half. Fold the top right corner to the left.

STEP 2: Cut

Cut the excess so that you now have a square piece of paper.

STEP 3: Fold

Fold as demonstrated.

STEP 4: Cut

Make 9 incisions for the sharks’ back as shown.

STEP 5: Glue

Use your Bostik Tri Stick to glue the lower two halves of the shark’s belly together.

STEP 6: Cut

Using the left over blue sheet of paper, fold it in half and cut 2 x 7cm x 7cm squares. Cut the rest as demonstrated for the fins and lower jaw. Cut 2 small circles out of the black sheet for his eyes (or you can use a black marker on the white sheet).

STEP 7: Glue

Start gluing your shark together starting with the fins and the tail.

STEP 8: Teeth

Cut a strip of A4 white paper about 1 cm wide for the teeth. Fold in half. One half you will cut out the teeth and the other you will glue to the shark’s mouth.

STEP 9: Cut & Paste

Cut a serrated edge as shown on one side of the paper. Cut into three sections, and glue into the shark’s mouth.

See all products